The MPEG2-TS signal applied to the analyser and decoder can be selected from either the front-end or the ASI input. The selected MPEG2-TS is then available on 2 identical ASI outputs.

• The extracted MPEG2-TS from the COFDM Front-End or from the ASI input is analyzed according to the standard TR 101 290.
• The services selected in the TS by the user, video PID and audio PID, are decoded.
• The video composite decoded signal is supplied on a BNC connector at the front of the equipment.
• In parallel the RGB color components are provided on a D-SUB /HD 15 pins (VGA type) connector.
• The selected audio channels is supplied on XLR 5 type connector.

• 1 (or more) alarm is (are) provided for each measurement. The alarm threshold can be user set individually.
• 4 synthesis alarms are provided to allow the combination (logical or) of 1 or more alarms according to a table defined by the user.
• 3 pre-defined synthesis alarms (RF, COFDM et MPEG) are displayed on the front panel.
• Alarms configuration and status can be accessed remotely through the serial link or IP network (see below)

RS232 serial link: a console monitor grants full access to the equipment: configuration, measurements, alarms.
Ethernet PCP/IP proxy board: full remote control is available using HTTP FTP, SNMP protocols through an embedded http server and ftp and snmp clients

All embedded softwares can be downloaded through remote control access (RS232 or Ethernet)